Modine™ PDP Gas Unit Heater, 400000 BtuH Input, 332000 BtuH Output, Natural Gas, Propeller Fan, 4460 cfm, 1/2 Inch Gas Connection, 0.83 Efficiency, 6 Inch Flue/Vent, Power Vent, Motor Drive, Direct Spark Ignition, 21 ft Installation Height, 115 V, 9.8 A, 1 Phase, Aluminized Steel, 50 deg F, 40-1/4 Inch L x 28-5/8 Inch W x 34-3/4 Inch D
- Power exhaust that can be rotated 180 deg
- 83% thermal efficiency, maximizing seasonal efficiency through the use of a collector box and power exhauster
- 100% shut-off, intermittent pilot ignition system with continuous retry
- Field convertible from natural to propane gas
- Safety pressure switch to assure safe venting conditions
- Designed to use the smallest diameter vent pipe possible
- Wing screws so that the bottom pan can be dropped without a screwdriver
Standard/Approvals: CSA Certified, ETL Listed
Power Vented Gas-Fired Unit Heaters
The perfect way to efficiently heat an ample space such as a large pole barn or a commercial or industrial warehouse. Easy to use and time tested for quality and durability. The PDP model series expands on the size range of the Hot Dawg Series. Our commercial-grade power vent unit heaters come with either a propeller fan or centrifugal blower fan in seven different sizes.
83% thermal efficiency, maximizing seasonal efficiency through the use of a collector box and the power exhauster.
A power exhaust can rotate 180° allowing the unit to be vented vertically or horizontally.
A 100% shut-off if the unit does not light, to ensure that unburned gases do not build up in the unit.
An intermittent pilot-ignition system with continuous retry to keep the unit from locking and needing to be rest if the unit does not light on the first try.
All PDP/BDP units to be field-converted from natural gas to propane if desired.
A safety pressure switch monitors the vent pipe to assure flue gases leave the building and do not back up in the space.
Designed to utilize the smallest diameter vent pipe possible.
BDP models are designed to operate against 0.5 inches of external static pressure.
“Wing” screws so that the bottom pan can be dropped without a screwdriver or nut driver.
A level hanging mechanism for easy field adjustments after adding accessories that may change the unit’s center of gravity.
Designed, Engineered & Assembled in the USA
Finger-proof fan guard for operation at low mounting heights
Two Stage Gas Valve
Blower Motor
BMS capabilities
Accessories
High Altitude Kits
Vertical Deflector Blades
Deflector Hoods – available in 30°, 60°, 90° downward deflection
